• The grain tray with a capacity of 300g is removable to facilitate filling.
• The conical steel crusher crushes coffee delicately and silently
• The recovery tank may contain 150g of ground coffee

On this model, the quantity of ground coffee is determined by the version, either in manual mode, or by selecting a position. You will be able to refine the duration of version according to your cafes and the use (Italian coffee maker, espresso, filter, in piston ..)

	The button allows you to choose the version duration. 1 = Manual position 2 = 10 sec. (about 2 cups) 3 = 20 sec. (about 4 cups) 4 = 30 sec. (about 6 cups) 5 = 40 sec. (about 8 cups) 6 = 50 sec. (about 10 cups)
	Thanks to the lateral button, it is possible to adjust the version intensity (from 1 to 15 levels). 1 = fine ground (espresso machine) 15 = coarse grind (piston coffee maker)

Tips:

- Do not fill more than 300g of coffee beans in the grain tank

- Do not operate the coffee mill on continuous more than 5 min (risk of overheating)

- The device must cool for 30 min if you made it work without interruption for 5 min

- The coffee mill is automatically stopped after 90 min.

- Clean the crusher after each use to prevent the powder depot with damage to the device and alter the taste of coffee

cleaning and maintenance tips

- Before cleaning Remove the sheet from the wall outlet

- Clean the device well after use. Do not wait because it makes cleaning more difficult, and possibly impossible.

- Too much fouling may, if necessary, degrade the device

- Humidity penetration in the device can deteriorate the electronic components

- Do not use aggressive or abrasive cleansing products and no solvent

- Do not scratch resistant dirt with sharp objects

- Do not dive the device into water or in another liquid and do not put in the dishwasher.

cleaning

- Disassemble the grain tray and rinse the under the water tap, do the same for the lid, the coffee powder tank and its lid.

Dry each element carefully.

Moulin body:

- Lift the handle of the mill and unscrew it in the opposite direction of the needles of a watch, to dissociate it from the wheel. Clean the engine axis nut with a brush.

-Nettoy the grinding body under the water tap and dry it then carefully.

- Replace the body of the mill and tighten it in the direction of the needles of a watch until it is well blocked.